There’s nothing quite as frustrating as fighting with a faulty garage door. Day after day, you struggle to get it open, certain that it shouldn’t be this hard to get to work!
Thankfully, you don’t have to choose between expensive visits from the repairman or battling the door forever; using the easy tips listed below, you can fix the door yourself and simplify your entire life.
Fixing the Garage Door
Garage doors work with the use of spring tension; these springs provide the power necessary to move the door up a set of metal tracks along the wall and open the garage for you to easily move your car.
Before you start, make sure that your garage door is not designed with only one torsion spring; if it is, put away your tools and call the repairman, because this particular design can be dangerous.
If your door doesn’t want to open, use these simple repair tips:
#1. Check for Broken Pieces
Thoroughly examine the track to make sure that no pieces are broken or damaged. Don’t fool yourself into thinking that half your track has to be gone to cause a malfunction; even small crimps or dents in the track can cause problems.
Once you locate the trouble area, smooth it back to its normal position using a hammer or rubber mallet. If the track is too damaged to repair, it’s time to go buy a new piece.
#2. Make Sure it’s Aligned
Few people enjoy employing a level, but this frustrating tool is exactly what you’ll need to make sure that the tracks are properly aligned. Tracks that run horizontally should slant a little down the farther they get in the garage, while roll-up doors should be exactly plumb against the surface. If you are not sure about how to do this, you can contact a trusted garage repair service to help.
Tracks have to start at the same place on the garage walls. If anything is out of place, you can fix it by loosening screws and bolts, gently tap the track back in place using a hammer, and then re-tightening the screws.
#3. Check for Loose Screws
Speaking of screws, those may just be the problem! Over time, screws and bolts that were once tight can become lose. Check all of your screws and make sure that they are tight. If the screw can no longer be tightened due to an over-sized hole, chose a larger screw that will fit snugly.
#4. Clean it Up!
You don’t usually think of the garage door being included in your cleaning regime, but gunk and dirt can cause operation problems. Clean up the track and rollers using a diluted all-purpose cleaner, then wipe dry with a clean cloth.
#5. Install a New Garage Door Opener
You may discover that it’s the actual mechanics of the opener that are faulty. While it’s not an easy job to repair the opener itself, replacement is simple and can be easily accomplished following the directions on the back of the box.
Use the tips listed above to help you identify and fix problems that might be causing your garage door to malfunction. You’ll thank yourself when you leave for work and the door magically opens!